Grasshopper

algorithmic modeling for Rhino

Created with David Ruttens ToyCar Script. When I used Grasshopper to create surfaces, the strips didn't turn out single curved.

Views: 2941

Comment

You need to be a member of Grasshopper to add comments!

Comment by Mårten Nettelbladt on September 16, 2009 at 2:47pm
Hi Jesse, I unrolled those surfaces manually. No grasshopper involved.
Comment by Jesse Pietilä on September 16, 2009 at 12:18pm
I need some UnrollSrf, is this in away the same ?!
Comment by Mårten Nettelbladt on June 3, 2009 at 2:17pm
Thanks Michael, I remember you emailed this to me earlier (in March). Can you please explain to me what is happening? What are the inputs you need to do this wrapping?
Comment by Michael Grau on June 1, 2009 at 3:48am
that reminds me on something. note that the surface is not a cone but a sheet wrapped around a point, thus a more general solution

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service