01

Comment

Comment by Mariam on November 29, 2010 at 1:36am

Thanks a lot!

Comment by tommy on November 29, 2010 at 1:31am

http://www.co-de-it.com/wordpress/code/grasshopper-code

Comment by Mariam on November 28, 2010 at 11:55pm

Hi Tommy. I've tried to make a pattern like this previously but I don't know how to panelize a hexagonal pattern through a surface. Since I started from dividing a surface in U and V directions, the centers of modules were located one above the other. Although I made a simmilar look but I had not each hexagon individually. Can you explain how you've made that?
Thanks- Maryam