Grasshopper

algorithmic modeling for Rhino

Views: 244

Comment

You need to be a member of Grasshopper to add comments!

Comment by Nathan Lucero on October 20, 2011 at 12:26pm

Thank you for posting your work! Good stuff. 

Comment by Troy Malmstrom on October 20, 2011 at 12:24pm

Yes, after we used GH to layout and label all the parts we used RhinoNest to create the cut sheets.  We used 12"x96" cedar boards and a 1/4" up-spiral bit using a 1/2" part to edge distance and a 3/4" part to part distance.  After running the program several times we found our optimal arrangement and ran 4 boards at a time on our 48"x96" router table.

Thank you for the interest

Comment by Nathan Lucero on October 20, 2011 at 12:10pm

This is amazing work. Did you use any software to layout the parts? 

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service