this target list:
(a1, b1, c1, d1)
(a2, b2, c2, d2)
(a3, b3, c3, d3)
....
What I want to do is injecting one more value (arbitrary angle in my case) to each point before I cull many of them - so that each point brings its angle data along.
Any hep would be greatly appreciated. TIA
…
blinds be (B1,B2..B5). Then the geometry for the five iterations will be ((A+B1), (A+B2)...(A+B5)).
And assume that you are measuring illuminance at four points inside the room (x1,x2,x3,x4) and one point outside the room(y1).
The way Daysim works ( and should work as per the best of my understanding) is that for each setting of the blind (ie. B1,B2,..B5), a separate value of (x1,x2,x3,x4) gets calculated through the Daylight Coefficient Method. So let's say you have illuminance thresholds of (p,q,r,s,t) corresponding to (B1,B2,..B5). What the shade-control algorithm does is that it compares the illuminance at y1 with your threshold of (p,q,..t) and then chooses a value of (x1,x,2,x3,x4) on basis of that. So, when we repeat this process for (365x24=)8760 hours , we end up with a value of a shade setting for each hour which was set on basis of your threshold illuminance values.
I would have gladly answered your question on HB itself, however, I usually work with Daysim directly through commandline.
(BTW, if you are interested in reading more about Daysim google Christoph Reinhart's dissertation on the subject, along with some papers by Zack Rogers).…
, a1200)}) Is there any way I can make this list into {a1, a2, a3, a4, -a5, -a6, -a7, -a8, a9, a10, a11, a12, -a13, ..... , a1200} ? ( 4 positive signs then 4 negative signs and so on) - alternating every nth in general.
or
2. Is there any way (workaround) to get negative angle value from 2 vectors? I know 'ANGLE (of 2 vectors)' component by itself doesn't work and I know why too. I have feeling that the reflex angle output might be useful but again, matter of list manipulation.
Any help would be greatly appreciated. Thanks in advance.
Hyo
…
on for curves, if you make an algorithm that dynamically defines the possition of the controlpoints for NURBS curves as a function of the parameteres in F(t, a1,...,b1,...,c1,...)= x(t, a1, a2...)+y(t, b1, b2...)+ z(t, c1, c2...) or F(x, a, b ,c...)?
…
I'm trying to extrude a large number of them to the next surface below, they're not all at the same distance from one another so it'd have to be 84 Z components for the 84 surfaces there