fdm 3D MODEL

Comment

Comment by aggadea on February 16, 2016 at 3:26pm

Rough resolution*

Comment by aggadea on February 16, 2016 at 3:25pm

I was using ultimaker 2.0 tough resolution, so my guess is that I could at least double the quality

Comment by martyn hogg on February 16, 2016 at 3:23pm

They look really nice printers!

Comment by Birk Binnard on February 16, 2016 at 2:35pm

My printer is an Atom2. It makes prints that are a higher quality than any non-commercial printer I"ve seen.  Here's the website: http://www.atom3dp.com/en/atom2/#top

Comment by martyn hogg on February 16, 2016 at 1:25pm

What printers are you using?

Comment by Birk Binnard on February 16, 2016 at 10:39am

This is a part I made some time ago using some WeaverBird components. It came out better than I had expected.