Grasshopper

algorithmic modeling for Rhino

Thicken Spatial Gridshell

Hey Guys,

im working on a gridshell for my diploma.

At the moment, i'm able to thicken the upper and lower level of the grid seperately.

Im looking for a solution to thicken the whole mesh and bake a single brep or mesh for 3D Printing.

does someone has got any solution?

best regards, Leo

Views: 1106

Attachments:

Replies to This Discussion

Permalink Reply by Luis García Lara on April 5, 2013 at 2:28pm
Permalink Reply by Leo Beltramo on April 6, 2013 at 8:07am

Thank you very much :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service