Grasshopper

algorithmic modeling for Rhino

1. WbProcessingException - topv_count is 2 or less! Error

Hi guys,

I am quite desperate for some help. I have non closed lines that I need to create a mesh from. Using WB produces this error (1. WbProcessingException - topv_count is 2 or less! - Weaverbird was unable to produce a valid result because of this). Another way I can achieve the result I need without going through extremes?

Many thanks in advance.

Views: 1113

Replies to This Discussion

Permalink Reply by Giulio Piacentino on May 28, 2019 at 2:52am

This error happens when there are too few points in a mesh. Are you sure that the mesh is complete?

Permalink Reply by Sam on May 28, 2019 at 2:54am

I am actually trying to make a mesh from lines I have and failing miserably.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service