Problems running Wallacei

I have used Voronoi as a planning strategy and introduced a lot of parameters for controlling it. Whenever I run wallecei, it crashes within 5 seconds. I cannot figure out what is causing it. I even removed the fillets to reduce computing time.

Please suggest how to solve this problem. I have attached the rhino and grasshopper file for your reference.

Thanks.

Attachments:

Experiment 1_Trial.gh, 116 KB
Experiment 1_Trial.3dm, 204 KB

Replies to This Discussion

Permalink Reply by Mohammed Makki on October 13, 2020 at 9:05pm

Hi, you are using a few plugins that i dont have on my machine and so i cant oen your file.. please send me the plugins (i tried downloading them but i may have not found the correct ones).

Permalink Reply by Elise on October 14, 2020 at 12:12am

Hi Makki.

Thank you for your prompt reply. I have attached the plugin setups. After installation, their folders have to be added to Grasshopper developer setting for functioning.

Thanks.

SYNTACTIC_V_2.7.exe

Cheetah_SetUp.exe

Permalink Reply by Mohammed Makki on October 14, 2020 at 12:45am

the file still thinks the plugins are missing.. are you using rhino 5 or rhino 6?

Permalink Reply by Elise on October 14, 2020 at 1:38am

It is Rhino 6.

Permalink Reply by Elise on October 14, 2020 at 7:12am

Hi. I have removed the Space Syntax and Configurbanist components from the script.

It is still having issues running wallacei. Can you please have a look?

Thanks.

Experiment1_Trial2.3dm

Experiment1_Trial2.gh

Permalink Reply by Mohammed Makki on October 22, 2020 at 4:39am

Hi Elise,

the simulation is running fine on my end.. there was one issue in the definition that i fixed.. you had 11 objectives in a single number parameter.. the maximum number of objectives per number parameter is 10.. if you add more than that then Wallacei UI wont open. I split your objectives so that there is a maximum of 10 values per number parameter.

Experiment%201_Trial%202_mm.gh

Permalink Reply by Elise on October 26, 2020 at 9:22am

Hi.

Thank you for resolving the issue. Really appreciate the help.

I am also facing another issue. It would be a great help if you can share your thoughts on it.

Whenever I run Wallacei, (I run it for mostly 80-100 populations) I either get results and wallacei runs its whole cycle within 10 mins or it crashes. There is no other option. Any idea why that would be?

Thanks.

RSS