algorithmic modeling for Rhino


I noticed a problem and cant find out solution.

For some unknown reason fitness values ouputed by wallacei do not coincide with fitness values entering wallacei. Is there any possible way to keep the results as well as get correct fitness values?

Thanks in advance 

Views: 38


Replies to This Discussion


Please make sure you have the latest version (2.55), this will fix your problem in this case. 

And of course when you update to the latest version you need to rerun the simulation.

Also one side note: make sure to flatten the number parameters holding your objectives before inputting them to WallaceiX.

Hello Milad,

I have the same issue. I do use the latest version 2.55, yet I come across this issue on every optimization. But, I did not make my objective's numeric parameter as flatten. I will do it and check again.

Hi Akash,

That should fix your problem. Let me know if the problem persists, and if so please share your file so I can take a look at your problem.






  • Add Photos
  • View All

© 2020   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service