All Discussions Tagged 'and' - Grasshopper2024-03-29T14:07:14Zhttps://www.grasshopper3d.com/group/pachyderm/forum/topic/listForTag?tag=and&feed=yes&xn_auth=noChrash for getting the simulation mapping methodtag:www.grasshopper3d.com,2022-10-29:2985220:Topic:22671862022-10-29T23:00:25.154ZAlireza Mohammadihttps://www.grasshopper3d.com/profile/AlirezaMohammadi
<p>Hello to every one.<br></br>I am getting a simulation of a residential complex in pachyderm. I need to say that I have tried a lot to model the project clear. because due to I was working with rhino 6 till last week and I have entered the model from sketchup the based model was mesh based so I have model and convert a lot of mesh objects to nubes so lots of time the model did not run for simulatio beacuse it had bad objects in itself until I got success to remove and repair bad objects but now…</p>
<p>Hello to every one.<br/>I am getting a simulation of a residential complex in pachyderm. I need to say that I have tried a lot to model the project clear. because due to I was working with rhino 6 till last week and I have entered the model from sketchup the based model was mesh based so I have model and convert a lot of mesh objects to nubes so lots of time the model did not run for simulatio beacuse it had bad objects in itself until I got success to remove and repair bad objects but now after running the simulation when I want to get the mesh gradient on the surfaces of the simulated project suddenly the rhino crash and close completely. I had this problem for another project once and it was due to the size of meshes but when I got the mesh sizes larger it soved and the software gave the result. but right now how much I change the size of meshes it would not change in results and with each size of mesh resolutions the analysis result would not give me the mesh results and it will crash and close rhino.<br/>I would really thank you if some body can help me to find the problem if is there any problem in the file. But I am really desperate and I don't know where the problem is with the file. And it is possible that the problem is due to the defect and weakness of my system configuration?<br/><br/></p>