Grasshopper

algorithmic modeling for Rhino

hi all,

I was using the m+FaceArea component to get area of faces for a weighted avg calculation. For curved planar surfaces (200m2 - 1000m2) it was taking a lot of time, grid size 0.1m. takes a few mins sometimes.

I used the honeybee generate test points component just now and it is 100 times faster. BUT what I noticed is that the m+ component gives double area for each face. Can someone double check on this? Is it a bug? if yes then I have done a lot of calculations wrong in the past :P As long as weighted avg is concerned it would have been still okay though. 

Thanks

Views: 273

Attachments:

Replies to This Discussion

Saket,

You are correct, the area value was doubled.

This was a bug.

Version 2.1.03 fixes this.

Ah okay. Thanks for the information. I will update. 

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service