Grasshopper

algorithmic modeling for Rhino

Diamond populate bug?

I am trying to divide a surface(the green one in the img) into diamond panels but instead of dividing it, its dividing a bigger surface.What am i doing wrong?

P.S. I think its something about the trimmed surfaces.

Thanks,

Tudor

Views: 356

Attachments:

Replies to This Discussion

Permalink Reply by Nicholas Cecchi on March 25, 2013 at 4:02pm

It appears as if you projected a curve onto the surface GH is showing in red, then trimmed to make the surface shown in green. LunchBox components do not work on trimmed surfaces.

Your best bet would be to re-build the surface you want using the loft command.

Permalink Reply by Nedelcu Tudor on March 25, 2013 at 4:26pm

thank you for your fast reply. i will try that. Thank you

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service