Grasshopper

algorithmic modeling for Rhino

Hi all ,

Hope my message finds you well , I have this issue of " 1. None of the connected srfData could be matched with the surfaces in the connected HBZones " when visualizing the surface data results. Also when visualizing the results by zone I had the results of roof & floor only , So what should I do to visualize surface data ? 

plz find attached the gh file & the epw file  .

thank you , 

Mona 

Views: 276

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Hi mona,

Your zones not created correctly.

You have 73 surfaces, that HB assumes each surface as a zone!!

It is needed to define each zone must be a "close Brep".

To create Zone from HB surface  use "Honeybee_createHBZones"

 Then to solving adjacent zone walls for defining interior walls, air walls and etc, use  Honeybee_Solve Adjacencies.

See 1 and 2,

-Omid

Hi Omid , 

thanks for your help , I was confused how to draw my building as it's a large one consists of many zones in 4 floors & I need to study the thermal & energy performance of the whole building. I will draw it again & I will share with you results :)

Regards,

Mona 

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service