Grasshopper

algorithmic modeling for Rhino

Hello!

I have a quick question concerning the view analysis component.

When I input a list of BREPS in the _geometry plug, are they also taken into account as obstacles to the view? or should I add them to the context_ plug?

In practice: if I input some building façades in _geometry, _viewpoints can see through façades as if they were transparent when the same façades are not in the context_ plug?

In other words: _geometry can block view rays to other sensors on the same _geometry?

Thank you for your answer. Hope it was clear enough

Pietro

Views: 918

Replies are closed for this discussion.

Replies to This Discussion

Hi Pietro,

The short answer is yes. In all Ladybug analysis components geometry will block view rays. You need to remove the transparent parts of the geometry before connecting them to the component.

Mostapha

Thank you very much Mostapha :)

Pietro,

I just wanted to add that, for the view component of the last stable release and all typical uses of the view component into the future, the _geometry will block the view as Mostapha states.  However, there were two new capabilities that I recently added into the component where I realized you usually do not want the geometry to block the view and so I do not have this _geometry block the view.

These cases are 'spherical view' and 'horizontal 60 degree cone of vision' which are used primarily for indoor studies when you are trying to maximize overall view to the outdoors (as opposed to view towards a given destination object for which you would use a series of points).  In these two cases of spherical and cone of vision, your _geometry is usually the plane of vision and so you do not want this plane to block the view.

My comment here will be more relevant after the next stable release.

-Chris

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service