Grasshopper

algorithmic modeling for Rhino

unable to locate the centroid of window surface correctly

It seems the centroid of the window surfaces of a thermal zone cannot be identified correctly, and some of them are trimmed surfaces and the others are untrimmed surfaces...

May I ask what might be the course of this problem and how to solve it?

THanks!

Views: 256

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Omid Rashidi on September 23, 2016 at 4:55pm

Hi Ji,

For evaluate center of the window surfaces use surface component and reparametrize that.

or use area component to find center of the surfaces.-Omid

Permalink Reply by Grasshope on September 24, 2016 at 12:28am

Thank you very much, Omid!

Good to know the reparameterize requirement to get centroid correct.

I noticed that we may need to flatten the list of window surfaces if they are from different zones.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service