run e+ simulation error

Hi everyone

thank you for helping and responses

I'm trying to do some simple energy plus stimulation with honeybee. but when I run the component, I face with this error :

1. The simulation has not run correctly because of this severe error:
** Severe ** GetSurfaceData: Potential "OtherZoneSurface" is not matched correctly:

1. The simulation has failed because of this fatal error:
** Fatal ** GetSurfaceData: Errors discovered, program terminates.

I check the idf file, and I believe, I assign every thing right. I cant realize why this happening. would you plz take a look at the file bellow and let me konw what the problem is..

I really appreciate all the help.

Thank you,

Mehrnaz

Attachments:

first simulaton.gh, 612 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Devang Chauhan on December 1, 2016 at 5:21am

Hi Mehrnaz,

I took a look at your model. I have following observations that I would suggest you look into.

1. Your air wall surfaces are partly inside the zone and partly outside the zone. I would recommend you assign them EP construction as per exposure.

2. Your surfaces for Roof and Floor overlap.

3. Surface Type "Roof" is assigned to many floors

I have not looked further than checking how you prepare your geometry. So the root of error may not be the way you have assigned surfaces. However, to follow a good modeling practice I would suggest you address these issues.

-Devang

Permalink Reply by mehrnaz on December 1, 2016 at 7:27am

thank Devang for your helping...

you're right , but when I use solve adjacency component all this individual roof surface redefined again to the floor and the air walls located inside the model.. after i use the solve adjacency component,i check this issue with honeybee label zone component and all the surface type assign correctly

RSS