Grasshopper

algorithmic modeling for Rhino

Recolor mesh component error

Hi everyone, 

I'm getting an error from the Recolor mesh component. The error says" the length of the results[=1] is not equal to the number of mesh faces [=218]. I don't see a reason to have such an error because I did input 218 faces to the mesh input. Please see attached picture

Views: 636

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on November 27, 2016 at 4:57pm

1. This is a warning and not an error. If you flatten _analysisResults input number of values will match the number of mesh faces.

2. Why are you grafting testPoints input?

Permalink Reply by Ninja on November 27, 2016 at 7:06pm

You're right, it's just a warning. I updated my HB version and everything works fine now. I didn't even notice that I grafted the test points. Thanks Mostapha

Rania

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service