Grasshopper

algorithmic modeling for Rhino

re-colorMesh

Hi Tangminghao,

re-ColorMesh gives you the chance to customize the presentation of the result (which is a mesh) before you bake it. It is most useful in cases that you are dealing with multiple studies and you want to have a consistent presentation (eg. normalize the legends). It is also useful to customize the presentation for or a study that takes so long to re-run.

You can apply the similar changes using legendPar input in the component itself but then you have to re-run the study.

I attached an example file that shows how you can normalize the legends, change the colors and add custom comments.

Hope it helps,

Mostapha

Views: 3925

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Xinyi Wu on October 22, 2015 at 11:01am

hey mostapha, when the amount of analysisresult and input mesh don't match, the re-colored mesh would have some problem

Permalink Reply by Xinyi Wu on October 22, 2015 at 11:02am

If I just would like to change the legend bar

Permalink Reply by Mostapha Sadeghipour Roudsari on October 22, 2015 at 3:16pm

This post is pretty old. I just replied to your new discussion.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service