Grasshopper

algorithmic modeling for Rhino

RAD Material

Hi all,

i have just noticed this funny thing when i create a new RAD material..

As you can see from the following image, even if my input for RGB is 0.719335202, the RAD material present 0.784.

Do you know why?

Thanks a lot in advance

Claudia  

Views: 372

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on August 16, 2016 at 8:33am

The input values are transmittance values however radiance uses transmissivity values (output). The component converts transmittance values to transmissivity and that's why you see different values in input versus output.

Permalink Reply by Claudia on August 16, 2016 at 8:38am

Ah, ok! Right!

Thanks a lot!!! I was already putting the values of the transmissivity!

Thanks for the super quick response

Claudia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service