One Legend for Multiple Zones in Daylighting Simulation

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on November 22, 2016 at 12:49pm

join the mesh and flatten the results: http://www.grasshopper3d.com/group/ladybug/forum/topics/remove-lege...

Permalink Reply by Ladan GD on November 22, 2016 at 2:33pm

Thanks Mostapha, I created them like this (see the file attached) but it didn't work. I used "Mesh Join" and "Flatten Tree". Is there another command that I should use?

thanks

Ladan

Attachments:

• HBLegend.PNG, 133 KB

Permalink Reply by Devang Chauhan on November 22, 2016 at 9:27pm

Hi Ladan,

As Mostapha said, You need to join the meshes (not flatten) and flatten the illuminance values in order to have a common legend. I attached an example file. It is the same I sent you earlier. I have prepared a common legend in the file for your reference.

Devang

Attachments:

• Test2.gh, 573 KB

Permalink Reply by Mostapha Sadeghipour Roudsari on November 22, 2016 at 9:30pm

1. You need to flatten the input before the MeshJoin and not after. If you do it correctly the output of MeshJoin should be a single joined mesh.

2. Flatten the results of the analysis before connecting them to recolorMesh.

Basically what we are trying to do is to change the results of different surfaces to look like the results of the analysis with a single surface.

Permalink Reply by Ladan GD on November 23, 2016 at 10:07am

Thank you very much Mostapha and Devang, it worked! that's perfect! I am attaching the file for others reference. 

So many thanks to you!

Ladan

Attachments:

• HB-One Legend for Multiple Meshes.PNG, 166 KB

Permalink Reply by Devang Chauhan on November 23, 2016 at 10:43am

Cool!