My Honeybee always simulates annually and gives me only one value!

Hi,

I am working with new version of Honeybee. I make a very simple zone and wanted to test it. When I run the file, its results are annually, but I want the hourly results. I change the timestep in the into the hourly, monthly and daily, but the results are annually again! I open EnergyPlus file to check the variables, and all of the frequencies of the variables are annual.

What is the problem of my Honeybee?

Thanks alot.

Regards,

Helia Taheri

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Helia Taheri on August 13, 2016 at 11:37pm

I think it does not run well.

Attachments:

Untitled.png, 353 KB

Permalink Reply by Abraham Yezioro on August 13, 2016 at 11:46pm

From what i see the simulation did run well.

Can you check the contents of the c:\ladybug\unnamed\EnergyPlus directory?

-A.

Permalink Reply by Helia Taheri on August 14, 2016 at 12:07am

I check this directory which you said. I put the read HB_readEPReslults on my canvas and plug result file address to it. but it is orange and tells me that "the result file doesnt exist".

Is this a problem with my HB? or I am simulating in a wrong way?

Attachments:

Untitled.jpg, 335 KB

Permalink Reply by Abraham Yezioro on August 14, 2016 at 2:21am

Since you didn't upload the last file you are using i took Chris's 123_CWM.gh. It run fine on my system.

So i would ask if are you sure you have write rights in the c:\ladybug directory?

Have you succeeded with other cases?

If no, please give, in the workingFolder input, a location in your computer where you are sure the previous rights are granted.

Also, can you check at the bottom part of the panel with the report what is written in there? Your previous image doesn't show it and it looks suspiciously short compared with what i get (see image).

-A.

Attachments: