My Honeybee always simulates annually and gives me only one value!

Replies to This Discussion

Permalink Reply by Chris Mackey on August 9, 2016 at 11:05pm

Helia,

It sounds like you just have to disconnect the "annually" input from the "Generate EP Output" component.  If that's not working, upload a GH file with the issue.

-Chris

Permalink Reply by Helia Taheri on August 9, 2016 at 11:11pm

Chris,

At first I want to thank from you for your very useful video tutorials on Honeybee energy modeling. They were very useful for me. 

I upload the file which has the mentioned problem.

Thanks,

Helia

Attachments:

• 123.gh, 516 KB

Permalink Reply by Chris Mackey on August 10, 2016 at 12:29am

Results seem to be hourly as far as I can tell:

Attachments:

• 123_CWM.gh, 528 KB

Permalink Reply by Helia Taheri on August 10, 2016 at 12:37am

Thanks Chris,

I open your file, although in your picture it is hourly, in my PC is annually! 

Is there problem with my Honeybee?

Attachments:

• Untitled-1.jpg, 257 KB

Permalink Reply by Mostapha Sadeghipour Roudsari on August 10, 2016 at 7:00am

Helia, Can you send a screenshot which includes simulation outputs component and also upload the idf file and output from readMe.

Permalink Reply by Chris Mackey on August 10, 2016 at 8:09am

Also, Helia,

Please include the file address of the resultFileAddress.  It may be that the component is not giving you the result file from the most recent simulation.

-Chris

Permalink Reply by Helia Taheri on August 13, 2016 at 10:26pm

Mostapha,

These are the files which you told. I hope my problem solve.

Thanks

Helia

Attachments:

• unnamed.expidf, 205 KB
• unnamed.csv, 22 KB

Permalink Reply by Helia Taheri on August 13, 2016 at 10:32pm

This is the screenshot.

Attachments:

• Untitled.png, 287 KB

Permalink Reply by Abraham Yezioro on August 13, 2016 at 10:48pm

Helia,

Your idf is showing that the calculations should be reported hourly.

Can you delete the whole c:\ladybug\unnamed directory and then run the simulation again?

-A.

Permalink Reply by Helia Taheri on August 13, 2016 at 10:58pm

Abraham,

I delete it and run it again. 

After deleting and running again, my folder includes 2 files, an idf file which I attach it again here and a batch file. 

But my honey bee is again runs annually and it takes a veryyyyy short time for simulating whole year. 

Permalink Reply by Helia Taheri on August 13, 2016 at 11:00pm

I attach the files.

Permalink Reply by Abraham Yezioro on August 13, 2016 at 11:11pm

Can you check the report output of the HB_runEnergySimulation?

Plug it to a panel. You should see there if the simulation run well.

-A.

• ‹ Previous
• 1
• 2
• Next ›
• Page