Multiple Surfaces_DA Analysis_Mesh results problem

Hi all,

I am doing DA analysis regarding multiple surfaces but the mesh results turned out to be that " Length of the results [X] is not equal to the number of mesh faces [Y]". I tried to flatten the mesh list and join them together. But it still had the same problem.

Can anyone help?

Thanks very much in advance!!!!!!

Attached the gh.. The 3dm. file is too big I will try to compress it and upload later.

Fig 1: surface of interest

Attachments:

DaylightAutonomySimulation.gh, 553 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Maria X on April 28, 2016 at 10:19am

attached .3dm file

Permalink Reply by Maria X on April 28, 2016 at 10:54am

Permalink Reply by Mostapha Sadeghipour Roudsari on April 28, 2016 at 1:03pm

Does the analysis generate any results?

Permalink Reply by Maria X on April 28, 2016 at 5:54pm

Attachments:

2.png, 145 KB

Permalink Reply by Maria X on April 28, 2016 at 6:03pm

Hi Mostapha,

I attached my partial .3dm. (The parts of interest have been placed into 'window', 'non-glazing' and 'testing level'. Could you help me a quick check?

Thanks in advance!!!!!!!!!!

Attachments:

20160429_Partial Model.3dm, 3.7 MB

Permalink Reply by Maria X on April 28, 2016 at 8:06pm

Hi Mostapha,

I used another computer to do the simulation again with the same files feed, but the error message was different now. There is no output for DLA but with the warning: index out of range 0. I am really confused now.

Could you tell me what's going wrong?

Permalink Reply by Chris Mackey on April 29, 2016 at 1:41pm