Grasshopper

algorithmic modeling for Rhino

itersectMass component error

got a strange error using the intersecting mass component: "1. This component only works with raw Rhino brep geometry and not HBZones.  Use this component before you turn your breps into HBZones."

Once the type hint of the intersecting mass component is changed from Brep to ghdoc, the error is gone:

But two of the exterior wall surfaces were wrongly recognized as interior wall surfaces:

This happened after I updated LB and HB just now. Am I missing sth here?

Views: 172

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on April 12, 2017 at 8:25pm

I just recreated the geometries as breps and not HBZones and it works fine on my machine.

Permalink Reply by Grasshope on April 12, 2017 at 9:36pm

Yes, Mostapha, I'm unable to reproduce this error, either....

Thanks, anyway.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service