Issue with Graphics (How to Change to Wire-frame Preview)

Hello

This might be a very easy question, but I have been having trouble getting rid of my back box in Rhino when I run grid-based daylighting simulation. and I cannot see my results due to that.

I am using an example file provided in Hydra website. When I change the way windows are introduced to the model, the back box is created. Simulation is running, that I can tell. But I don't know how to make the box disappear to see my results.

Thank you very much

Ladan

Attachments:

CCC_Honeybee_Grid-based_Daylight_Simulation_Good.gh, 491 KB
HB-Wire.PNG, 157 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Antonello Di Nunzio on November 20, 2016 at 2:58pm

Hi Ladan,

if I have understood correctly, you mean how to disable the preview of the building brep. Just right click on brep and set preview off.

you should enable the preview of wireframe components as you can see below:

Antonello

Permalink Reply by Ladan GD on November 21, 2016 at 10:05am

Hi and thank you. I did the exact same thing and I still see the black box. I had done that before sending my file too. Could it be a setting in my Rhino view or my GH view?

Permalink Reply by Julia T on November 21, 2016 at 10:12am

Try to select everything in the grasshopper file, disable the preview and then enable only the simulation. Probably you have something, somewhere, enable and you haven't noticed

Permalink Reply by Mostapha Sadeghipour Roudsari on November 21, 2016 at 11:04am

...and hide the geometry in Rhino, our turn off the layer preview.

Permalink Reply by Ladan GD on November 21, 2016 at 11:49am

It's because I am not a pro in Rhino or GH. It's very funny but irritating ;) I created the HB file again from the scratch. now my favorite box, which doesn't dissappear is red. I think it is related to my Rhino.

Please check out this new HB file. ( I had to flip by grid, because HB picked my wall instead of floor to create an analysis mesh. and I don't know if it will be a problem later in my energy modeling, anyhow.. )

Please help me with this graphic issue. I appreciate that.

Attachments: