honeybee splitmass error

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on January 18, 2016 at 9:05am

Hi Aleme. Are you trying to create an energy model for this shape? This model is not a model that you want to split between perimeter and core zones. Check Introduction to EnergyPlus document to read more about thermal zones and zoning.

Mostapha

Permalink Reply by Alemeh Afzali on January 18, 2016 at 9:48am

Hi Mostapha

tnx for your attention,acctually i have only one zone under this dome,i dont know how to describe its windows to honeybee to analyse heating and cooling energy use for my building,when i connect it to hb glazing ratio it just get confused and doesnt recognize my dome az only a roof,whats your suggestion about this problem

Permalink Reply by Mostapha Sadeghipour Roudsari on January 19, 2016 at 10:33am

Have you watched Chris's videos on how to put an energy model together with Honeybee? Preparing an energy model for your shape as a single zone is quite straight forward.

Permalink Reply by Tim on January 31, 2016 at 3:26am

Hi Alemeh,

Mostapha is right, you need to simplify it a bit.

I'm watching the tutorials and recommend to check them out, they help a lot.

Specifically about your problem: one, two and three.

Permalink Reply by Mostapha Sadeghipour Roudsari on January 31, 2016 at 5:47pm

=))) Very true!