Grasshopper

algorithmic modeling for Rhino

Honeybee grid based simulation Issue

I'm trying to perform a grid based daylight simulation. The issue Is that the process get stuck at the oconv stage (see image).

I tried to follow this discussion:

http://www.grasshopper3d.com/group/ladybug/forum/topics/honey-bee-i...

but no use.

I'll appreciate any help on this.

Thanks,

Gal

Views: 567

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by gal kapon on June 17, 2016 at 9:27am

Hi, I tried to rung it, it gets stuck in the exact same spot.

Gal.

Permalink Reply by Abraham Yezioro on June 20, 2016 at 12:20am

Just to inform.

The issue was happily solved by uninstalling and installing Radiance (5.0 64b).

Thanks,

-A.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service