Error with old image based simulation and new image based simulation

Hi,

When I run an image based analysis it works for the older component but with the new component I am receiving an error which I can't understand (see attached picture)

Attachments:

Image based bug RR 7.14.gh, 511 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on July 14, 2016 at 3:40pm

Can you share the .err file from inside the study folder?

Permalink Reply by Roya R on July 15, 2016 at 7:33am

Please find it attached here:

Attachments:

error.txt, 1 KB

Permalink Reply by Mostapha Sadeghipour Roudsari on July 15, 2016 at 9:09am

Thanks. This should not give you an error. I will get this fixed later today or tomorrow.

Mostapha

Permalink Reply by Mostapha Sadeghipour Roudsari on July 15, 2016 at 12:41pm

Roya, The analysis is running on my machine with no issues. I'm not sure why it give you an error. Can you try to set the number of cpus to 1 and then run the analysis? Make sure you have the view set correctly and can see the room in the view.

Permalink Reply by Chris Mackey on July 21, 2016 at 2:41am

Roya,

We just realized what the issue is after seeing a few people encouner this in a workshop. When you see the black command line window pop up, DO NOT close it. This is a window indicating that the analysis is running. If you close it, the analysis will stop running before it finishes and you will get the error that you have reported here. If you wait for the window to finish, it will close on its own when the analysis is done.

-Chris

RSS