Grasshopper

algorithmic modeling for Rhino

Error with HB_indoor radiant temperature map

Hi, 

I had the following error in this script to find out the MRT distribution in a room: 

"1. None of the connected srfIndoorTemp could be matched with the connected surface names and view factors. Note that this component does not currenlty work for curved geometry E+ simulations because the surfaces are broken up and meshed in order to run it through E+."

The thing is it worked the first time I run the simulation but then I changed some parameters and I have not been able to make it work again. 

Views: 1620

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on January 13, 2015 at 12:27am
Thanks Chris,
You are the best. Works, as you say: perfectly.
-A.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service