Grasshopper

algorithmic modeling for Rhino

Error using LB Radiation component

Hi everyone :)

I get really weird radiation analysis results and I don't understand why... I tried switching to a different epw, cancelled the "type hint" options on all the components (which seemed to be the problem last time), checked the srf dir, switched surfaces (made a new surface and inserted it into GH)... didn't work. 

When I connect a different polysurface from the same Rhino model it does work. Any ideas?

Views: 262

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Antonello Di Nunzio on June 13, 2016 at 3:58pm

Hi Adi,

Could you share your file again? The geometries seem to be empty. Thanks.


Antonello

Permalink Reply by Adi K on June 13, 2016 at 4:34pm

Sure, sorry about that

Attachments:
Permalink Reply by Antonello Di Nunzio on June 13, 2016 at 5:27pm

Hi Adi,

your file works fine,

Could you connect a panel like in the image above?

Best

Antonello

Permalink Reply by Adi K on June 13, 2016 at 5:41pm

strange... the sky matrix seems fine, but if I connect a panel to the analysis OUT, it gives an error. 

Attachments:
Permalink Reply by Mostapha Sadeghipour Roudsari on June 13, 2016 at 6:02pm

What are the units of your model is set to? If you don't know type units in Rhino command line and press Enter.

Permalink Reply by Adi K on June 14, 2016 at 12:01am

Meters

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service