Grasshopper

algorithmic modeling for Rhino

Error in Run Energy Simulation

I have prepared a file for Energy Simulation for a single room. The last time I used the file it was running the simulation. But now when I opened it again it is showing fatal error.

1. The simulation has not run correctly because of this severe error: 
** Severe ** IP: IDF line~11 Did not find "ProgramControl" in list of Objects

1. The simulation has failed because of this fatal error: 
** Fatal ** IP: Errors occurred on processing IDF file. Preceding condition(s) cause termination.

What can I do to run this simulation again ? 

Views: 1342

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on November 30, 2016 at 5:12pm

What is the version of EnergyPlus that you're using? Can you share the idf file?

ProgramControl should be added to the idf file by default as 1. It's not an input that you can change with the Honeybee interface so I wonder if there has been a change in the newer version of EnergyPlus.

Permalink Reply by Mansi Dhanuka on November 30, 2016 at 8:51pm

I have installed both EnergyPlus 8.50 and EnergyPlus 8.60. I am uploading the idf file. 

Thanks 

Attachments:
Permalink Reply by houshang tabriz on February 12, 2017 at 4:19pm

Hi Mostapha... I have this problem too. how to fix it? please help....

Thank you

Permalink Reply by Omid Rashidi on February 12, 2017 at 7:05pm

Houshang,

You need to update HB & LB and update these components.

Download and install the newer version from Food4Rhino.

Permalink Reply by houshang tabriz on February 14, 2017 at 3:01pm

Thank you Omid for your reply.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service