Error in honeybee during illuminance analysis

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on November 30, 2015 at 5:20pm

Hi Tim,

This is a warning about non-palanar surfaces and happens when you have a non-planar surface which has quad non-planar mesh surfaces even after meshing. If the number of errors are not so many you can disregard it. What is the tolerance value in your model?

You may want to mesh the geometry beforehand and use msh2RAD component as an alternate workflow. Check this discussion: http://www.grasshopper3d.com/group/ladybug/forum/topics/add-shading...