Grasshopper

algorithmic modeling for Rhino

Duplicate Surfaces: after Running E+

Hi All,

Why does energy plus create duplicate surfaces? I reworked on the model again but all my surfaces are getting duplicated.

I have attached my file just in case!

Views: 249

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Antonello Di Nunzio on August 2, 2016 at 3:35pm

Hi Vinu,

The issue is because you have connected three different zone programs to the same HB zone.
You should use "HB item selector" and it should be fine.

Best

Antonello

Permalink Reply by Vinu Subashini on August 2, 2016 at 3:47pm

Thank you! I forgot that part.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service