Grasshopper

algorithmic modeling for Rhino

Daylight factor not working?

Hi, I just started working with honeybee but I ran into a problem

I get 0% of daylight factor all the time, even when using a simple box.

Ideally I would like to use also the FRAMES object for shading, but connecting it gives me error

My honeybee component is orange - it says I do not have energy plus installed, even after installation

I am attaching my file

Views: 506

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Antonello Di Nunzio on April 15, 2016 at 4:45am

Hi Mateusz,

The problem is because test points are under the floor:

you should move your grid up.

You can also connect frames to your model.

Best

Antonello

Permalink Reply by Mateusz Mazurek on April 15, 2016 at 5:57am

Thank you, I will test it soon. Never thought that I positioned test grid wrong :D

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service