Grasshopper

algorithmic modeling for Rhino

Cannot create a postprocessing folder after running the simulation

Hi all,

I try to create a model to simulate the ventilation effect of solar chimney. Before the step of the running simulation, there is no issue. But the solution contains nothing. And the reminder shows that cannot find probes files under the postprocessing folder.

Thanks for your help!

 

Views: 368

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Omid Rashidi on April 24, 2017 at 12:29pm

Hi Tan, 

"locationInMesh issue"

Because by default BF sets the locationInMesh to the center of the case, so in this case it was outside.

You need to set a Point3d inside the mesh manually.(snappyHexMesh component>locationInMesh input).

Please find attached.

Best.

Attachments:
Permalink Reply by Tan,Shengji on April 24, 2017 at 3:34pm

Hi Omid,

Thank you so much for your wonderful reply!I learn a lot from this mistake.

I appreciate your help!

RSS

About


McNeel Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service