Grasshopper

algorithmic modeling for Rhino

Hello everyone,

I reinstalled my OpenFoam and VM recently and from then the following errors started popping up with every CFD I run. The errors are:

Error1

1. Solution exception:Failed to find points file at C:\Users\Neeharika\butterfly\outdoor_airflow\constant\polyMesh

Error2

1. Solution exception:Failed to load values:
Failed to find probes folder folder at C:\Users\Neeharika\butterfly\outdoor_airflow\postProcessing\probes


Any suggestions how can I overcome this error

Thank you

Views: 1435

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Neeharika,

The folder runs with no issues on my machine. There is an issue with you installation. Follow these lines in the command line and tell me what happens.

Mostapha,

I did enter the first command "cd workingDir/butterfly/outdoor_airflow/" and it says no such file or directory.

Then I would check create case component and see where the folder is created.

Create case component shows that folder is created in the right location.

This means the VM and butterfly are looking into two different folders. Did you install VM and OpenFOAM both as an admin?

In my case, I have only one user account system, so I installed both the OpenFoam and VM just by double clicking on the setup file.

One thing I want to make sure is that, by installing as an admin do you mean that even while installation I need to run my setup file as an admin?

Yes.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service