Grasshopper

algorithmic modeling for Rhino

Karamba3D Discussions (684)

← Back to Karamba3D
Discussions Replies Latest Activity

Linear cut in mesh shell

Hello, is it possible in a shell to simulate a linear cut made from one point along the edge of the shell to a certain point in its interio…

Started by Vale

1 Jun 22
Reply by Karamba3D

active bending

hello! has anybody already some experience with active bending in karamba? how can i introduce prestress? is there an approach on that conc…

Started by Henning Duerr

1 Jun 22
Reply by Karamba3D

Fixing the legend scale [SOLVED]

Hello everyone, I am trying to compare different structures in one figure using the same scale. So in other words, I want to use the same…

Started by Nathaniel Rasmioen

1 Jun 18
Reply by Nathaniel Rasmioen

Trapezoidial distributed load in Karamba3D

Hi everybody, Is it possible to apply a Trapezoidial distributed load in Karamba3D? A workaround that I could think of is splitting…

Started by Rayaan Ajouz

1 Jun 13
Reply by Karamba3D

Optimization voronoi diagram-nodal displacement

Hi, I want to try to optimize my Voronoi diagram by minimizing nodal displacement. I tried to use Galapagos where I put as Genomes the coun…

Started by Marinella Contestabile

2 Jun 3
Reply by Marinella Contestabile

Load combination - Beam results

Hi, I am making my load combinations through the model view and LCFactor. I was wondering how could I take the elements' resulting forces…

Started by Marina

1 May 30
Reply by Matthew Tam

Karamba3D example "Shell Cross Section Optimization“”

Shell Cross Section Optimization I have Rhino 6, Karamba3D 1.3.1 and Octopus 0.4. When load the gh file, it shows "current state of octopu…

Started by Sean

1 May 30
Reply by Matthew Tam

Shell & Cable: Connectivity Issue?

Hello, I’m studying a shell structure stabilized with cables. I scaled down the problem to a simple shell structure with pre-tensioned cab…

Started by Mohamad Tuffaha

2 May 29
Reply by Mohamad Tuffaha

impossible to make a joint beam

Hi every one, here is my problem: On the first picture you can see my model. In this model I would like all the point I put in red on the…

Started by Pommy

1 May 26
Reply by Karamba3D

Tensioning cables in Karamba

Hia, I was wondering if it's possible to post tension a cable in Karamba. At the moment I'm modeling a cable-stayed bridge and I would lik…

Started by Merijn de Leur

10 May 15
Reply by Merijn de Leur

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service