Karamba3D Discussions (750)

Sort by:

Discussions	Replies	Latest Activity
Shell Analysis Hi all, I've been trying to analyze a shell but i am not sure about the load condition, because i wanted to give a uniform load to the whol… Started by Davide Rando	1	Dec 22, 2017 Reply by Joseph Beard
material utilization - mesh resolution + model view Hello, I am working on a model of concrete building containing of slabs (shells) + columns and beams (beams). I have two questions regardin… Started by Wujo	2	Dec 20, 2017 Reply by Karamba3D
Cantilever element Hi Could you help me please; I have a doubt about my modeling. I have element in aluminum recessed on one side and loaded on the other. I… Started by sandra	1	Dec 19, 2017 Reply by Karamba3D
Large deformation analysis with cable-like elements Hello, I'm using the LaDeform component to approximate large-deformation behaviour of a tensile membrane with cables. Unfortunately, my a… Started by Lucas Epp	3	Dec 15, 2017 Reply by Karamba3D
pattern hinges karamba Hello all, I am trying to make a beam grid that is connected as shown in the picture. There are no primary and secondary beams, but they… Started by popi papa	7	Dec 14, 2017 Reply by Matthew Tam
bending moment changes according to the size of cross-section? Hello all, I made a simple vertical structure, and set supports at the top and bottom points. bottom : rigid connection; all blocked top… Started by Jaeman PARK	11	Dec 12, 2017 Reply by popi papa
Diseño estructural en Karamba Estoy aprendiendo a usar Karamba, tengo la siguiente duda: En Karamba se puede diseñar estructuras metalicas de acuerdo a una normativa com… Started by Jhoseph =)	4	Dec 11, 2017 Reply by Jhoseph =)
Beam joints problem Hello everyone, I have a problem with the 'beam-joint agent' component. When I plug it Karamba says that I have 127 rigid body modes in the… Started by Alessia Annunziata	3	Dec 11, 2017 Reply by Karamba3D
karamba error Hello, i have this kind of problem, i know which problem i have but i want understand wich is the rapid way for solve, the problem is this:… Started by francesco pasi	3	Dec 11, 2017 Reply by Matthew Tam
Defining Supports Dear all, after discovering Karamba I was very enthusiastic about the software. But now I always fail when it comes to setting the suppor… Started by Niklas Haschke	0	Dec 9, 2017