Grasshopper

algorithmic modeling for Rhino

thremal load on cross section

Hello

I am quite new on the topic and Karamba, so my question may be silly.. anyway.

I have a hollow circular section beam fixed at both ends and I simply want to apply a thermal load to its section as in the picture.

I tried to do it in Karamba but I see nothing.

What do I do wrong??

Thank you all!

Views: 380

Attachments:

Replies to This Discussion

Permalink Reply by Karamba3D on November 27, 2015 at 12:51am

Hello Valentina,

the temperature load in Karamba 1.1.0 is uniform over the cross section height. In oder to see a deformation in your example one support in the axial beam direction needs to be removed (see attached definition).

The cross section object you created was fed into the input-plug for the element identifier of the temperature load. Therfore the load component was not applied to the element.

Best,

Clemens

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service