algorithmic modeling for Rhino

Karamba3D Discussions (751)

Sort by:

Discussions	Replies	Latest Activity
Shell Wind Analysis Hello Clemens, I am running into an issue: I need to perform an analysis on a surface that will be an installed pavilion on a beach. I op… Started by Bradley Bowers	1	Jan 23, 2018 Reply by Karamba3D
Verifying results Hi For my thesis project I am optimizing a folded steel plate structure in Grasshopper. For the structural calculations I use Karamba. Ev… Started by Reinout van Arnhem	5	Jan 19, 2018 Reply by Karamba3D
HOW TO ADD A SUPPORT IN THE MIDDLE OF THE BEAM HI If i want to add a support in the middle of the beam, i dont know how does it works. Started by CHILEMENI	2	Jan 18, 2018 Reply by CHILEMENI
Providing memeber cross section in karamba and comparison of modelled results with actual strucutre. Hello, This is my first educational project on Karamba, therefore some questions are very basic so please pardon me for that. 1. I am work… Started by Anand Shah	0	Jan 15, 2018
Providng scissor type hinge joints in Karamba between continous memebrs Hello, I am very new to Karamba. I am working on design and analysis of a timber gridshell using Kangaroo and Karamba. I need to provide sc… Started by Anand Shah	4	Jan 15, 2018 Reply by Anand Shah
Point load placement in Karamba Hi For a simple test, i applied point loads to a simple 'tent' structure. I've put a list of the points into the 'Loads'-element, but if I… Started by Reinout van Arnhem	1	Jan 9, 2018 Reply by Karamba3D
Analyze solids Hi, A few friends and I, recently started modelling a bench made out of concrete (GRFC concrete). The legs of the bench are circular and an… Started by Tsvetan Donov	1	Jan 8, 2018 Reply by Karamba3D
Beam Optimization Hi, I am new to Karamba and Grasshopper, so I am basically copying all tutorials I can find on youtube. I did a simple cantilever beam with… Started by Tsvetan Donov	2	Jan 8, 2018 Reply by Tsvetan Donov
Shell Analysis Hi all, I've been trying to analyze a shell but i am not sure about the load condition, because i wanted to give a uniform load to the whol… Started by Davide Rando	1	Dec 22, 2017 Reply by Joseph Beard
material utilization - mesh resolution + model view Hello, I am working on a model of concrete building containing of slabs (shells) + columns and beams (beams). I have two questions regardin… Started by Wujo	2	Dec 20, 2017 Reply by Karamba3D