Use a metaball curve planar to Kangaroo

Replies to This Discussion

Permalink Reply by Daniel Piker on October 1, 2012 at 5:09am

Hi Thijs,

Your definition is almost there - it's just that the points you have chosen as anchors do not coincide with vertices of the mesh, so they do not restrain it. You could fix all the edge points of your mesh like this:

Permalink Reply by Thijs van der Lely on October 1, 2012 at 3:15pm

Great, thank you very much Daniel. Works like a charm!

Permalink Reply by Arthur Lara on October 1, 2012 at 5:53am

Thijs

I´ve an older everbird, but your metaballs will work if you put one more slider like the green one (see photo)...

Attachments:

• metaballs.JPG, 34 KB