Grasshopper

algorithmic modeling for Rhino

Hello,

Often when I'm trying create some model, i want to have rigid elements. But when i use very high stiffness springs (over 1e7 for example) model collapses. I've tried using small time steps an so on but it doesn't work. Is there a way to create very rigid frames without using springs or bend resistance (also doesn't work)? If not, will there be in the future?

Thanks.

Views: 403

Replies to This Discussion

Hi Danijel,

 

It should be possible to simulate spring stiffnesses even over 1e7 if you make the timestep small enough.

(I'd suggest something like 2e-4). Of course smaller timestep means slower simulation. You can increase subiterations (to say 60) to counteract this a bit.

 

And yes, I am hard at work on some new techniques aiming to improve things so that significantly stiffer springs will be possible in Kangaroo while still keeping a reasonable simulation speed.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service