algorithmic modeling for Rhino
Pull to curve - Iterative
Hi.
Is it possible to add a attraction power between to curves? Not with a spring at a specific point, but more en general? So that the two curves will stick to eachother at what intersection point is most convenient.
Like bending to rods and the one "below" will hit the one up "higher" and can not move anymore.
I hope that it makes sense, otherwise I will try explain again.
Best regards Rasmus
Views: 387
Replies to This Discussion
-
Permalink Reply by Daniel Piker on
-
Yes, this makes perfect sense and is something I'm already working on - it will be in the next release!
(and also collisions between line segments)
-
-
Permalink Reply by Rasmus Holst on
-
Sounds nice Daniel. Looking forward to the next release. Do you know if you will be implementing material properties as we talked about?
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2024 Created by Scott Davidson.
Powered by
