Grasshopper

algorithmic modeling for Rhino

Optimizing for specified edgelengths

Hello everyone!

Is it possible with Kangaroo to optimize a certain topology onto a surface, so it has only a few specified edgelengths?

The goal would be to not have transition between the edgelengths, but approximate a few specified values as much as possible.

I have been trying using springs and applying multiple values to Rest length, but no luck so far.
Any ideas how I could achieve this?

Thanks in advance!

sassom

Views: 1450

Replies to This Discussion

Permalink Reply by taz on August 21, 2014 at 6:14pm

Oh, and Spiderweb has clustering capabilities.  I keep meaning to play with it too.

http://www.grasshopper3d.com/photo/clustering2

Permalink Reply by Bart H on April 8, 2020 at 11:23am

Hello Daniel,

This is exactly what i’m trying to do. However, it uses some old Kangaroo 0.098 which I can’t use with Kangaroo2. Is there an alternative approach I could use?

Thanks

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2021   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service