Grasshopper

algorithmic modeling for Rhino

Fabric : Pinching and twisitng issues with kangaroo physics

Hi. GH users. I have been trying to simulate something similar ( pinching and twisting the fabric) as the image above with Kangaroo plug-in. Initially I thought it could work with vortex but it seems not working properly. Please find the attached file for your information. If it says that there is missisng component, please install plug in from the link below. http://www.grasshopper3d.com/group/starling

Can anyone advise me on that? Thanks in advance.

Views: 705

Attachments:

Replies to This Discussion

Permalink Reply by tasos on November 24, 2013 at 6:31am

hello i am interest about the same thing ! did you find any solutions ?

Permalink Reply by kwanphil cho on November 27, 2013 at 3:31am

I haven't really looked into it after I came accross the wall. I will let you know if I find something. Sorry.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service