Bend Sheet anchor Points

Hi All,

I am a novice with Kangaroo so please excuse my knowledge level, I have been testing a number of the examples posted by Daniel specifically one relating to plane optimisation and bending sheets.

However I am having a strange Issue with the example of sheet bending posted on the thread below. When I start the simulation only one of the anchor points is working therefore the sheet sucks into the one point that is working. 

I am using the latest building of kangaroo and Grasshopper, I have tried a number of different changes but am yet to solve this issue, if anyone could point me in the right direction that would be really helpful. 

Cheers 

Iain

http://www.grasshopper3d.com/group/kangaroo/forum/topics/new-versio...