Grasshopper

algorithmic modeling for Rhino

All Discussions Tagged 'bending' (7)

← Back to Kangaroo
Discussions Replies Latest Activity

Bending membrane with different warp and weft strength

Hello! I'm trying to simulate tensile membranes with elastic boundary and different warp and weft strength. The result with the same tensio…

Started by Agata K

0 Jan 28, 2019

Plywood Strips Bending Simulation

Hi, I have set up the ply strip bending analysis in Kangaroo to match roughly what I can observe in the physical material but I was wonder…

Started by Agata Korzeniewska

0 Oct 29, 2018

Bending rods and auxetics

Hi Daniel and everyone I am trying to simulate auxetic structures in K2 that are based on elastic materials (this is a very good example).…

Started by Claudio Campanile

0 Jun 6, 2017

Bending resistance + twisting resistance?

Dear Group (and Daniel in particular I guess),   I'm trying to use Kangaroo for simulating 3d-bending of a developable ribbon surface. Kang…

Started by Mårten Nettelbladt

3 Nov 23, 2015
Reply by David heaton

Kangaroo surface inflection paperlike

Hi Everyone I'm trying to simulate a surface inflection like in the image below I tried a simple definition that I found in the forum an…

Started by Agnieszka

0 Oct 23, 2012

curved / kinked folding of paper

I'm trying to simulate kinked bends in paper or thin plywood. How can I create a triangle mesh with edges of equal length? I guess I need s…

Started by Martin Siegrist

1 Apr 8, 2012
Reply by Martin Siegrist

Arduino, FireFly + Kangaroo, why do I get this error? SOLVED

Hi! I'm moving a Kangaroo anchor point with a slider (x value) and it's working fine. When I replace the slider with values from FireFly (A…

Started by Mårten Nettelbladt

1 Feb 23, 2011
Reply by Mårten Nettelbladt

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service