Grasshopper

algorithmic modeling for Rhino

Hi Everyone, 

I am working with a site that lies in the intersection of four SRTM data plots. I managed to get the topo surface for each plot but cannot figure out how to line them up and join them into one surface. Any help would be appreciated. 

Thanks 

I-15%20Topography.gh

Views: 106

Replies to This Discussion

-also, just to note that SRTM plots seem to overlap a bit so baking and moving the surfaces does not work.

Hi Claire,

I would suggest getting the Points output from the Elk Topography component and use a Surface from Points component to reconstruct a single surface. The duplicate points generated might need some clean up though.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service