Grasshopper

algorithmic modeling for Rhino

rotate diamonds along a curve?

Hi,

I generated a grid of diamonds for scaling. But the problem is that they all pointed on one direction which makes the pattern boring. How can I rotate them along a curve?

I tried to make a vector between an end point and the center point and then rotate the vector to the tangent of the curve. But the result is wrong.

Anyone knows how to solve that? 

Thanks a lot!

Regards,

Dora

Views: 978

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on January 11, 2016 at 5:31am

Attachments:
Permalink Reply by Joseph Oster on January 11, 2016 at 12:38pm

Attachments:
Permalink Reply by Joseph Oster on January 11, 2016 at 12:58pm

Longer curves need more divisions in V - a higher 'V Count':

Attachments:
Permalink Reply by Joseph Oster on January 11, 2016 at 2:12pm

Clean, partitioned lists of diamond curves without duplicate lines.

Attachments:
Permalink Reply by Joseph Oster on January 11, 2016 at 3:01pm

Attachments:
Permalink Reply by Joseph Oster on July 14, 2016 at 12:30pm

Dusted off this gem and made cosmetic updates to better show the grid data structure of the geometry, both the "Grid Panels" from 'Isotrim (SubSrf)' and the diamond curves derived from each panel/SubSrf.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service