Problem with Sdivide (component divide surface)

Hello

I got a problem when I divide a rectangle made by the Rectangle component via Sdivide when baking in rhino.

I'd like to get all the vertices from the division (which I got in data) but it miss the "edge" one in the preview and when I back I got only the only one previewed shown?

Is there anyone who know where does the problem come from? Did I do anything wrong?

See the image attached...

Attachments:

Sans titre-1.jpg, 738 KB

Replies to This Discussion

Permalink Reply by Simon ROBIN on August 10, 2013 at 12:14am

Forgot to precise:

I use Grasshopper Version 0.9.0014 and Rhino Version 5.0 (5.1.20927.2230, 09/27/2012)

Permalink Reply by Danny Boyes on August 10, 2013 at 1:15am

The only thing that i can think of at the moment is that something is going wrong in the conversion of rectangle to surface. Try it with the plane srf component instead.

Permalink Reply by David Rutten on August 10, 2013 at 2:42am

If you convert curves to planar surfaces then you often end up with trimmed surfaces. I've written some code to make it work better on rectangles and other quadrilaterals, but that code is now only available in the Boundary Surface component. Try using that in between Rectangle and SDivide.

David Rutten

david@mcneel.com

Tirol, Austria

Permalink Reply by Simon ROBIN on August 10, 2013 at 8:22am

Thank you very much for your answers!